Videotec VIPNX - Manual (Page 4)

EN - English - I
nstruc
tions manual
2
6 Assembling and
installing
h Only specialised personnel should be
allowed to assemble and install the device.
6.1 Installation
h Before carrying out any operation
remember to disconnect the product from
the power supply.
h For the version powered at 230Vac it is
necessary to insert a monopolar 1 0 switch
(open contact distance d>3 mm) upstream
of the appliance. This switch should be used
to disconnect the power supply before
carrying out any maintenance or opening
the appliance.
6.1.1 Glass window replacement (only
for NXM housing)
To install the kit on the NXM housing the standard
glass window should be replaced with the special
one supplied with the kit.
Remove the front flange (01) on the housing by
unscrewing the 4 screws (02).
Replace the standard glass (03) with the special glass
(04) and insert it in its special seating on the flange.
Reassemble the flange on the housing taking care
to insert the related seals (05) correctly in their
appropriate housing.
Fasten the front flange to the housing body by
tightening the 4 screws.
03
01
04
05
02
Fig. 01
4 Identification
4.1 Product description and type
designation
Wiper kit which can be directly installed on the
housing body. Wiperblade and enclosure constructed
from AISI 316 stainless steel. It includes the support
for the pump washing injector. Available in 24Vac and
230Vac versions, 7W max. Available for NXM, NXL,
NXJ series housings.
4.2 Product markings
See the label attached to the outside of the package.
5 Preparing the product
for use
h Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.
5.1 Contents and unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• Stainless steel wiper kit
• Instructions manual
5.2 Safely disposing of
packaging material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.