Kenwood TK-7185E - Manual (Page 21)

5
A
uxiliAry
p
orT
If a key has been programmed with the AUX A or AUX B function, you can press
that key to turn the Auxiliary Port on and off.
• When Auxiliary Port A is activated, the AUX A indicator ( ) appears on the
display.
• When Auxiliary Port B is activated, the AUX B indicator ( ) appears on the
display.
gpS r
eporT
If a GPS unit (NMEA-03 format) is installed on your transceiver and the Send
the GPS Data function has been programmed onto a key by your dealer, press
the Send the GPS Data key to send your location data.
h
ome
A
ddreSS
If a key has been programmed with the Home Address function, you can press
that key to jump to the pre-programmed call address.
• “HAD” appears in the sub-display when the selected call address is the Home Address
Press Home Address a second time to return to the previous call address you
were using.
S
iTe
l
ocK
Press and hold this key for second to lock the Site. "SITE LOCKED"
momentarily appears on the display. Press and hold this key again for second to
cancel Site Lock.
S
ub
-lcd d
iSplAy
If a key has been programmed with the Sub-LCD Display function, you can press
that key to toggle the sub-display between “SVC”, the current control channel
number, and the signal strength readout.
S
wiTching To
c
onvenTionAl
m
ode
Depending on how your transceiver is programmed, you can enter Conventional
Mode in one of two ways:
Manual: When in Trunking Mode, press the key programmed as Conventional
to change the operating mode. This function only works when no signals are
currently being received.
Auto: The transceiver automatically changes to Conventional Mode when you are
outside the network area.