Kenwood TK-7185E - Manual (Page 19)

3
c
All
d
iverTing
■
d
iverTing
y
our
o
wn
c
AllS
1 Enter control code 41 to divert your calls to a different transceiver.
2 Press the key, then enter the ID number of the unit to where you want
your calls diverted.
3 Press the PTT switch, the Call key, or the # key to set up the call diversion.
• “CALLING” appears on the display.
• When the call divert is set, “COMPLETE” momentarily appears on the display.
Additionally, the icon appears on the display and flashes.
4 To end the call diversion, enter control code #41, then press the PTT
switch, the Call key, or the # key.
• “CALLING” appears on the display.
• When the call divert is cleared, “COMPLETE” momentarily appears on the
display.
■ d
iverTing
T
hird
p
ArTy
c
AllS
1 Enter control code 44 to divert third party calls.
2 Press the key, then enter the ID number of the unit from which you want
calls diverted.
3 Press the key, then enter the ID number of the unit to where you want the
calls diverted.
4 Press the PTT switch, the Call key, or the # key to set up the call diversion.
• “CALLING” appears on the display.
• When the call divert is set, “COMPLETE” momentarily appears on the display.
5 To end the call diversion, enter control code #44 followed by the key and
the ID number of the unit from which calls are being diverted, then press
the PTT switch, the Call key, or the # key.
• “CALLING” appears on the display.
• When the call divert is cleared, “COMPLETE” momentarily appears on the
display.
d
iAling
m
ode
Press the key programmed as Dialing Mode to enter a dialing number using the
keypad.
Note: You can select Dialing Mode when Keypad Operation is set to Programmable.