Kenwood TK-7185E - Manual (Page 17)

S
TATuS
c
AllS
■
m
AKing A
S
TATuS
c
All
1 Press the and keys (Call Address Up / Call Address Down) to select
your desired call address.
2 Press the Status/ Stack key (default is the S key), then press the and
keys to select your desired status.
• The status number appears on the sub-display.
3 Press the Call key (or PTT switch if “PTT to Initiate Call” has been
programmed) to send the status.
• “CALLING” appears on the display.
4 When the status has been received by the called party, “COMPLETE”
momentarily appears on the display before returning to the previously
selected call address.
■
r
eceiving A
S
TATuS
/S
horT
d
ATA
m
eSSAge
c
All
1 When a call is received, the icon appears on the display and flashes.
• The icon remains on the display when there is data in the stack.
2 To view the status or message, refer to “Viewing the Stack”, on page 2.
d
ATA
c
AllS
■
m
AKing A
d
ATA
c
All
1 Enter control code 2 to make a SDM (Short Data Message) call.
2 Press the key, then enter your message.
• Enter characters using the keypad or by pressing the and keys. When
pressing the and keys, press the or C> key to set the selected
character.
• To clear a character, press the Clear key. To clear all entered characters, press
and hold the Clear key.
3 Press the key to end your message.
4 Enter the ID number of the unit you want to send the message to.
5 Press the PTT switch, the Call key, or the # key to transmit.
■ r
eceiving A
d
ATA
c
All
1 When a call is received, the icon appears on the display and flashes.
• The icon remains on the display when there is data in the stack.
2 To view the message, refer to “Viewing the Stack”, on page 2.