Kenwood TK-7185E - Manual (Page 16)

0
v
oice
c
AllS
■
m
AKing A
v
oice
c
All
1 Press the and keys (Call Address Up / Call Address Down) to select
your desired call address.
2 Press the Call key or the PTT switch to initiate the call.
• “CALLING” appears on the main display and “SVC” appears on the sub-display.
3 When the call is connected, a timer appears on the display.
• The timer can be set to either count up (increasing number) or down
(decreasing number).
4 Press the PTT switch to transmit; release it to receive.
• The LED lights red while transmitting.
• The sub-display shows your transmit power. A single triangle (▲) represents low
power and dual triangles (▲▲) represents high power.
5 Press the Clear key to end the call. If the call time expires before you press
the Clear key, the call will be automatically terminated.
• “END” momentarily appears on the display before returning to the call address of
the call you just made.
■
r
eceiving A
v
oice
c
All
1 When a call is received, the caller’s unit number appears on the main
display.
• If you have the caller’s address set up in your transceiver, the call address is
displayed instead of the unit number.
• Depending on the type of call being received, a code will appear on the
sub-display:
CAL: An individual call is being received.
GRP: A group conference call is being received.
BCC: A group broadcast call is being received.
• Special calls are denoted as follows:
I-FLEET: A call from a different fleet (Inter-Fleet).
I-PREFIX: A call from a different prefix (Inter-Prefix).
PABX: A call from a PABX telephone system.
PSTN: A call from a PSTN telephone system.
2 Press the PTT switch to respond to the call.
• The remaining call time appears on the display.
3 When the call ends, the display returns to the call address that was
previously displayed. However, if you end the call by pressing the Clear
key, “END” momentarily appears on the display before returning to the call
address.