American Megatrends MAN-758 User Manual

Page 56

MegaRUM PCI Motherboard User’s Guide

Advanced Setup,

Continued

Boot To SCO Unix Set this option to Yes only if running the SCO Unix v3.0, 5.0 or higher

operating system. The settings are Yes or No. The Optimal and Fail-Safe default
settings are No.

Boot To OS/2

Set this option to Yes if running OS/2 operating system and using more than 64
MB of system memory on the motherboard. The settings are Yes or No. The
Optimal and Fail-Safe default settings are No.

Floppy Drive Seek Set this option to Enabled to specify that floppy drive A: will perform a Seek

operation at system boot. The settings are Disabled or Enabled. The Optimal
and Fail-Safe default settings are Disabled.

Floppy Drive Swap Set this option to Enabled to permit drives A: and B: to be swapped. The

settings are Enabled or Disabled. The default settings are Disabled.

Floppy Access Control This option specifies the read/write access that is set when booting from

a floppy drive. The settings are Read/Write or Read-Only. The Optimal and
Fail-Safe default settings are Read/Write.

Hard Disk Access Control This option specifies the read/write access that is set when booting

from a hard disk drive. The settings are Read/Write or Read-Only. The Optimal
and Fail-Safe default settings are Read/Write.

S.M.A.R.T. For Hard Disks Set this option to Enabled to permit AMIBIOS to use the SMART

(Self Monitoring Analysis and Reporting Technology) protocol for reporting
server system information over a network. The settings are Enabled or
Disabled. The Optimal and Fail-Safe default settings are Disabled.

Cont’d