American Megatrends MAN-758 - Manual (Page 29)

Chapter 1 Hardware Installation 25
Step 9 Attach Cables, Continued
J13 VGA Interrupt Enable J13 is a 2-pin berg that enables interrupt support for the onboard PCI
ATI VGA controller:
Onboard PCI ATI VGA Interrupt Setting J13 Setting
PCI interrupt enabled for onboard PCI VGA. OPEN
PCI interrupt disabled for onboard PCI VGA. Shorted (Default)
J16 VGA Connector J16 is a 14-pin dual inline berg for the onboard ATI Rage II PCI VGA
controller. Connect the VGA cable supplied with this motherboard to J16. This
cable converts J16 14-pin berg signals to a standard DB15 VGA connector,
which can be mounted on the chassis. Make sure the red wire on the cable is
connected to Pin1 of J16. The pinout is:
Pin Signal Description Pin Signal Description
1 Red 8 Ground
2 Green 9 Ground
3 Blue 10 Ground
4 VSYNC 11 Fuse
5 HSYNC 12 Ground
6 MONID1 13 Ground
7 MONID2 14 Pin is Cut
VGA Cable and J16 Connectors The following drawing illustrates the VGA connectors on the
VGA cable and J16 on the motherboard:
Cont’d