Kenwood KDC-W9537U User Manual
Page 9
English
|
9
Volume
Increasing Volume
Turn the [VOL] knob clockwise.
Decreasing Volume
Turn the [VOL] knob counterclockwise.
Attenuator
Turning the volume down quickly.
Press the [ATT] button.
Each time you press the button, the Attenuator
turns ON and OFF.
When the Attenuator is ON, the "ATT" indicator
blinks.
Audio Control
1
Select the source to adjust
Press the [SRC] button.
Refer to
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Audio item
Turn the [VOL] knob.
Adjustment Item
Display
Range
Rear Volume
"REAR VOLUME"
0 — 35
Subwoofer level
"SUBWOOFER LEVEL" –15 — +15
Balance
"BALANCE"
Left 15 — Right 15
Fader
"FADER"
Rear 15 — Front 15
Exit Audio Control mode (Volume control mode)
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob, [
0] and
[ATT] button.
Audio Setup
Setting the Sound system, such as Volume offset
and Dual Zone.
1
Select the source to adjust
Press the [SRC] button.
Refer to
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item
Display
Range
Volume offset
"VOLUME OFFSET" –8 — ±0 (AUX: -8— +8)
Dual Zone System
"2 ZONE"
ON/OFF
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Dual Zone System
Main source and sub source (Auxiliary input) output System Setting> (page 41). - Select Main source by [SRC] button. (page 9). - The DSP Control will be disabled. • You can use the Dual Zone System only when you have set the rear speaker to any mode other than "None" in 5 Exit Audio Setup mode Press the [VOL] knob for at least 1 second. B64-3773-00_00_E_English.indd 9 B64-3773-00_00_E_English.indd 9 07.5.10 5:18:23 PM 07.5.10 5:18:23 PM
Front channel and Rear channel separately.
- Set up the channel of sub source by
- Adjust the volume of Front channel by [VOL] knob.
- Adjust the volume of Rear channel by
the