beautypg.com

Troubleshooting guide, Installation, Installation the bluetooth unit – Kenwood KCA-BT200 User Manual

Page 26

background image

26

|

KCA-BT200

Troubleshooting Guide

What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.

?

The hands-free talk volume is low.

✔ The hands-free talk volume is set at a low level.

☞ The hands-free talk volume can be adjusted

independently. Adjust it during hands-free talk.

?

No sound is heard from the rear speakers.

✔ You are talking in the hand-free talk mode.

☞ No sound is heard from the rear speakers in the

hands-free talk mode.

?

No beep is heard at reception of an incoming call.

✔ No beep is heard depending on the type of your

cell-phone.
☞ The is

set ON.

?

Voice is not recognized.

✔ The vehicle window is open.

☞ If the surrounding noise is large, voice cannot be

recognized properly. Close the vehicle windows
to reduce noise.

✔ Small voice.

☞ If voice is too small, it cannot be recognized

properly. Speak into the microphone a little more
loudly and naturally.

✔ The person uttering the voice tag is not the one who

registered the it.
☞ Only the voice of the person who registered the

voice tag can be recognized.

?

The Bluetooth audio player cannot be registered

(pairing).
✔ The PIN code is fixed.

☞ When a PIN code is specified in the Instruction

Manual for Bluetooth Audio Player, register it
with reference to to
register the Bluetooth audio player. If no PIN
code is specified in the Instruction Manual, try
“0000”.

?

The sound from the Bluetooth audio player is

discontinuous.
✔ The distance between this unit and audio player is

too far.
☞ Move the audio player nearer to this unit.

✔ Another Bluetooth device is affecting the Bluetooth

communication.
☞ Turn off another Bluetooth device.

☞ Move another Bluetooth device away from this

unit.

The messages shown below display your
systems condition.

No Number/ NO-NMBER/ Incoming No Number :

• The calling party does not notify a caller ID.
• There is no phone number data.

Installation

Installation the Bluetooth unit

¤

• Determine the installation position after making sure that

the unit can communicate with the Bluetooth device.

• Please do not install the unit near the dashboard, the rear

tray, or other important components. Doing so could lead
to injury or accident should the unit come off due to a
shock and strike a person or an important component.
Tapping screws should be used for mounting. (Attachment
with velcro strips, although easy, can come off with a
shock.)

Securing to audio board

Securing to pile carpet

Accessory

3

Antenna part

• Do not stick the velcro tape over the serial number.
• If the installation place is stepped, cut the velcro tape into

two pieces and stick them at two positions.

Antenna part

Accessory

2 (Ш4 Ч 16 mm)

B64-4121-10_01_KE.indb 26

B64-4121-10_01_KE.indb 26

08.2.25 2:10:29 PM

08.2.25 2:10:29 PM