Siemens HF25G5R2 - Manual (Page 11)

11
Error messages
You can take remedial action yourself for some error
messages.
After-sales service
Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
E number and FD number
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate bearing these numbers can
be found on the right-hand side when you open the appliance
door. To save time, you can make a note of the number of your
appliance and the telephone number of the after-sales service
in the space below, should it be required.
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
To book an engineer visit and product advice
Trust the expertise of the manufacturer, and rest assured that
the repair will be carried out by trained service technicians
using original spare parts for your domestic appliance.
This appliance corresponds to the standards EN 55011 and
CISPR 11. It is a Group 2, Class B product.
Group 2 means that microwaves are produced for the purpose
of heating food. Class B states that the appliance is suitable for
private households.
Technical data
Environmentally-friendly disposal
Dispose of packaging in an environmentally-friendly manner.
A signal sounds. The colon in the
display flashes. The appliance is in demonstration mode. 1. Press the
2 button.
2. Press and hold the g button for three sec-
onds.
Demo mode is deactivated.
Problem Possible cause Remedy/information
Error message Possible cause Remedy/Note
Error message "E723" appears in the dis-
play. The door is not properly closed. Open the appliance with the 3 button and
close it again.
Error message "Er1", "Er4", "Er18" or "E305"
appears in the display.
Technical malfunction. Call the after ­sales service.
Error message "Er11" appears in the dis-
play. "Button jammed"
The buttons are dirty or the mechanism
has jammed.
Press all the buttons several times. Clean
the buttons with a dry cloth. Open and
close the appliance door. If this does not
help, consult the after-sales service.
E no. FD no.
After-sales service O
GB 0844 8928999
Calls from a BT landline will be charged at up to
3 pence per minute. A call set-up fee of up to 6 pence
may apply.
IE 01450 2655
Power supply 230 V, 50 Hz
Maximum total connected load 1,990 W
Microwave power setting
900 W (IEC 60705)
Microwave frequency 2,450 MHz
Grill 1300 W
Fuse min. 10 A
Dimensions (HxWxD)
­ appliance
38.2 x 59.5 x 32.0 cm
­ cooking compartment 220 x 350 x 270 mm
VDE approved yes
CE mark yes
This appliance complies with European Directive
2002/96/EC on Waste Electrical and Electronic
Equipment (WEEE). The directive gives a framework for
the collection and recycling of old appliances, which is
valid across the EU.