Night Guard Home Surveillance System C3-RS-900LCD - Manual (Page 18)

18
Ignition Trigger CLEAR THE FLASH ICON AND MELODY SOUND: While
triggering the alarm the LCD screen will alert user through
melody sounds and flashing trigger icons. Pressing the
button 3 times within 3 seconds will clear the flashing
icons and stop melody sound on the LCD screen
transmitter.
STOP THE MELODY SOUND ONLY: While triggering the
alarm the LCD screen will alert user through melody sound
and flashing trigger icon, press any button on the LCD
remote transmitter to stop melody sound only.
NOISE ABATEMENT CIRCUIT: You system has “Noise Abatement Circuit”. It
prevents annoying repetitive trigger sequences due to faulty door pin switches
or environmental condition such as thunder, jackhammers airport noise, etc.
Here’s how “Noise Abatement Circuit” works: The alarm triggers 5 times. Each
time, the same sensor or switch is triggering the alarm. “Noise Abatement
Circuit” will interpret this pattern of triggers as false alarm. After the third
trigger, “Noise Abatement Circuit” ignores, or bypasses, that sensor or switch
until another sensor or switch is trigger.
“Noise Abatement Circuit” covers doors (Hood/Trunk) differently: If the alarm is
triggered by an open door for three full cycles, the doors will be bypassed until
the trigger ceases.
O. ANTI CAR- JACKING (programmable)
Warning: If you don't need the car jacking function in this alarm system, be
sure to set car jacking feature “OFF” in unit programming. This system has a
default setting of car-jacking feature “OFF”.
ACTIVE ANTI CAR JACKING:
1. Press and hold the transmitter and button at the same time for 2
seconds while the vehicle’s ignition is in the ON position. The parking lights
will turn on for 1.5 seconds to indicate that car jacking mode has been
entered.
2. Once the system is armed and you are forced from the vehicle, the system
will trigger when the door is opened and closed while the ignition is in the
“ON” position.
PASSIVE ANTI CAR- JACKING:
It operate as follows:
1. Turn the ignition switch to the “ON” position; the system will arm.
2. Once the system is armed and you are forced from the vehicle, the system
will trigger when the door is opened and closed while the ignition is in the
“ON” position.
TRIGGER THE ANTI CAR -JACKING MODE:
3-timer circuits will function as follows:
First timer:
a. 50 seconds after the system has been triggered. The siren will start
chirping for 15 seconds.
b. During this 15 seconds period of chirping, you will be alerted to push the
valet switch once to turn off the car-jacking feature.
c. If not, it will enter second timer of the car-jacking mode.
Second timer: 65 seconds after the system has been triggered.
The siren will start sounding and the parking light will start flashing.
Third timer: 90 seconds after the system has been triggered