Night Guard Home Surveillance System C3-RS-900LCD User Manual

Page 17

L. CAR LOCATOR

Under armed mode, press the

button to

activate the car locator function. The siren will chirp
6 times. The parking light will flash 12 times, for
you to easily locate your car.

M. PANIC FUNCTION:

The transmitter can be used as a remote panic switch to manually trigger the
alarm in case of an emergency.

1. Press and hold the

button for 3 second. The alarm

will immediately sound.

2. During panic mode, the normal function of this

transmitter button will be disabled. The transmitter

and

buttons can be used to lock and unlock the

door (if the option is installed), however once the

button is pressed, the vehicle’s starter disable device,
(where installed) will be disengaged allowing the
vehicle to start.

To stop the alarm, press and hold the transmitter

button on the

transmitter again for 3 seconds. If the button is not pressed, the alarm will
automatically stop after 30 seconds.

N. TRIGGER THE SYSTEM

When armed, your vehicle is protected as follows:
1. Light impact will trigger the warn-away signal.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the

ignition key will trigger the programmed sequence.

The starter disable relay (if installed) prevents the vehicle’s starter from
cranking. The siren, horn, parking lights, and dome light will turn on to alert the
user of an intrusion for 30 seconds. Then it will stop and automatic reset and
re-arm. If the one of sensors or detectors still active, the alarm system will
sound a maximum of 3 times of 30 seconds cycles.

Door Trigger

Trunk/Hood Trigger

Warn-away Trigger

Shock Sensor Trigger