Kenwood TS-990S - Manual (Page 243)

USEFUL FUNCTIONS 16
16-11
Index Contents
CONFIGURING THE KEY REPEAT DELAY TIME
You can configure the delay time until the key repeat
begins.
1 Select Group No. 9, "USB", from the Menu screen.
2 Access Menu 02, "Repeat Delay Time (USB
Keyboard)".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select the delay time.
• The key repeat speed can be selected from "1" to "4".
• The default is "2".
5 Press [ ] (F1).
6 Press [MENU] to exit.
CONFIGURING THE KEYING SPEED
You can configure the keying speed for the USB keyboard.
1 Select Group No. 9, "USB", from the Menu screen.
2 Access Menu 03, "Repeat Speed (USB Keyboard)".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5), or rotate the MULTI/CH
control to select the key repeat speed.
• The key repeat speed can be selected from "1" to "32".
• The default is "1".
5 Press [ ] (F1).
6 Press [MENU] to exit.
ENABLING USING USB KEYBOARD TO SEND A
MESSAGE
If the transceiver is configured as described below,
pressing a PF key on a USB keyboard transmits a Voice or
the text message.
• The transmission of a message using a USB keyboard is
enabled:
• "Voice" or "Message" is assigned to a PF key on a USB
keyboard:
Refer to the following for the method to assign a voice or a
text message to the USB keyboard.
• Recording a Voice Message {page 13-1}
• CW Message Memory {page 5-22}
• Utilizing an RTTY Message Memory {page 5-40}
• Utilizing an PSK Message Memory {page 5-57}
1 Select Group No. 9, "USB", from the Menu screen.
2 Access Menu 00, "Send Message by Function Keys
(USB Keyboard)".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "On".
The default is "Off".
5 Press [ ] (F1).
6 Press [MENU] to exit.
Note:
◆ Even if two sets of USB keyboards are connected to the
transceiver, the transceiver recognizes the USB keyboard
connected first.
◆ You cannot select a channel where no message is stored.
◆ In FSK or PSK mode, a message can be transmitted following the
configuration for the channel where a message is stored.
In FSK or PSK mode, a message can be transmitted while the
RTTY Encode/Decode screen is open.