Kenwood TS-990S - Manual (Page 218)

14-6
14 VOICE GUIDANCE
Index Contents
Screen Operation/Status Announced Content
RTTY/PSK message
When the screen opens or
[VOICE1] is pressed
(RTTY/PSK) + "Message"
When the screen opens or
[VOICE1] is pressed
"Channel" + Number + "Auto" + (TX/RX)
Switching a channel Number
Switching the automatic transmit "Auto" + "TX" + (On/Off)
Switching auto receive "Auto" + "RX" + (On/Off)
Editing a message
(Including when [VOICE1] is
pressed)
Editing a message
FM tone
When the screen opens or
[VOICE1] is pressed
(Main/Sub) + (Tone/CTCSS) + Frequency
Switching a tone type (Tone/CTCSS)
Changing the frequency Frequency
Starting the Tone/CTCSS scan (Tone/CTCSS) + Scan
Ending the tone CTCSS scan Frequency
Switching a band (Focused band) (Main/Sub)
Receive a filter
When the screen opens or
[VOICE1] is pressed
"RX filter" + (A/B/C) + (R/IF/AF) + Value
Switching a filter (A/B/C)
Switching to a roofing filter (Auto/270 Hz/500 Hz/2.7 kHz/6 kHz/15 kHz/Additional)
Switching the IF filter shape (Medium/Soft/Sharp)
Switching the audio filter
bandwidth
(Medium/Wide/Narrow)
Audio peak filter
When the screen opens or
[VOICE1] is pressed
"APF" + (Narrow/Middle/Wide)
Focus shift (Narrow/Middle/Wide)
NB1/NB2/NR1/NR2 level
(Sub-and)
When the screen opens or
[VOICE1] is pressed
"Noise blanker" + 1 + Value
"Noise blanker" + 2 + Value
"Noise reduction" + 1 + Value
"Noise reduction" + 2 + Value
Reset to the defaults No announcement
Switching configured value Value
Configuring auto notch
tracking speed
When the screen opens or
[VOICE1] is pressed
"Auto Notch" + "Tracking" + Value
Reset to the defaults No announcement
Switching configured value Value
Band eliminate filter
When the screen opens or
[VOICE1] is pressed
"Band elimination filter" + (Width/Depth) + Value
Bandwidth, Extent configuration (Width/Depth)
Switching configured value Value
Reset to the defaults No announcement
Bandscope
When the screen opens or
[VOICE1] is pressed
"Bandscope 1"
Bandscope and
Waterfall
When the screen opens or
[VOICE1] is pressed
"Bandscope 2"
Audio scope
When the screen opens or
[VOICE1] is pressed
Audio scope
Memory Channel List
When the screen opens or
[VOICE1] is pressed
"Memory List" + Number + (S/D/P/blank)
Only when write destination is selected: (Memory in) + Number + (S/D/P/blank)
Focus shift Number + (S/D/P/blank)
Saving or pasting the data No announcement
Programmable start frequency
entry
(End frequency entry)
"End frequency" + Used frequency
Clearing the channel data No announcement
Switching the lockout "Lockout" + (On/Off)
Confirming clear all for
Quick Memory
When the screen opens or
[VOICE1] is pressed
"Quick Memory" + "Clear" + "OK?"
Memory scan group
configuration
When the screen opens or
[VOICE1] is pressed
"Memory Scan" + "Group" + Number + (On/Off)
Focus shift Number + (On/Off)
Switching On/Off (On/Off)
Switching all On/Off
"Select all"
"Clear all"