Dake Model Super Technics 350SA - Manual (Page 7)

7
SUPER SUPER SUPER SUPER SUPER TECHNICS 350 SA TECHNICS 350 SA TECHNICS 350 SA TECHNICS 350 SA TECHNICS 350 SA
5.3 - Material feeding system
- Pneumatic device for material feeding.
4.6 - Instructions for electrical connection
- The machine is not provided with an electric plug, so the
customer must fit a suitable one for his own working conditions:
1 - WIRING DIAGRAM FOR 4 -WIRE SYSTEM FOR THREE-
PHASE MACHINE - SOCKET FOR A 16A PLUG
MACHINE FUNCTIONAL
PARTS
5.1 - Operating head
- Machine part composed of the parts that transmit movement
(motor, reduction unit).
5
5.2 - Machine bed and Vice
- Support structure for the OPERATING HEAD (rotating arm
for gradual cutting, with respective blocking system), the VICE,
and the housing for the cutting coolant TANK.
- System for gripping material during the cutting operation, by
means of the approach handwheel and pneumatic locking.
It is provided with an anti-burr device for blocking the part that
is to be cut.
R = L1
S = L2
T = L3
PE = GND
4.7 - Instructions for assembly of the loose parts
and accessories
Fit the components supplied:
- part. 1 Fit the feeding system
4.8 - Disactivating the machine
- If the sawing machine is to be out of use for a long period, it is
advisable to proceed as follows:
1) detach the plug from the electric supply panel
2) empty the coolant tank
3) carefully clean and grease the machine
4) if necessary, cover the machine.
4.9 - Dismantling
(because of deterioration and/or obsolescence)
General rules
If the machine is to be permanently demolished and/or scrapped,
divide the material to be disposed of according to type and
composition, as follows:
1) Cast iron or ferrous materials, composed of metal alone, are
secondary raw materials, so they may be taken to an iron
foundry for re-smelting after having removed the contents
(classified in point 3);
2) electrical components, including the cable and electronic ma-
terial (magnetic cards, etc.), fall within the category of material
classified as being assimilable to urban waste according
to the laws of the European community, so they may be set
aside for collection by the public waste disposal service;
3) old mineral and synthetic and/or mixed oils, emulsified oils
and greases are special refuse, so they must be collected,
transported and subsequently disposed of by the old oil
disposal service.
NOTE: since standards and legislation concerning refuse in
general is in a state of continuous evolution and therefore
subject to changes and variations, the user must keep
informed of the regulations in force at the time of
disposing of the machine tool, as these may differ from
those described above, which are to be considered as
a general guide line.