Caster installation, Scraper installation – Summers 84' Superroller User Manual
Page 22
SECTION 2 - ASSEMBLY
2-12
Caster Installation
Note: The caster wheel shown in Figure 6 is for the left hand side. The tire should be posi-
tioned towards the drum.
C1. Install 8P7190B as shown in the diagram, center 8P7190B on the caster wing. Attach with the
hardware shown, tighten all nuts.
C2. Install 7P8530 into the caster weldment, attach the spindle with the hardware shown and
tighten all fasteners.
C3. Install the assembled caster into the caster holder, be sure to install the wear plates and spac-
ers in the correct order.
C4. Tighten the Caster Castle nut so the caster assembly cannot be turned by human force. Install
the hardware in the castle nut as shown to ensure that it will not loosen.
C5. Install the castor pivot lock cylinder (8P0302) and all associated hardware as shown in the
diagram. Make sure the cylinder ports are pointing towards the roller.
Scraper Installation
S1. Install scrapers as shown in drawing on page 2-14. Use the hardware showin in detail A.
S2. Adjust scraper so they do not touch the roller.