Summers 84' Superroller - Manual (Page 14)

SECTION 2 - ASSEMBLY
2-4
Hitch Installation
H1. Position hitch as shown in Figure 2; install the pins and hardware shown in Figure 2.
IMPORTANT
Always install the pins with the cross hole towards the outside. Pay attention to the orien-
tation of the cross hole in the pin to the cross hole in the bushing on the main frame, only
drive the pin in far enough to line up the holes, install the fasteners shown in Figure 2.
H2. Install the jack stand and pin.
H3. Install the hitch clevis and hardware shown on the front of the hitch.
H4. Install the Pivot lock and cylinder at the rear of the front hitch. Install the pins and washers as
shown. Note the orientation of the pivot lock, do not install it backwards.