Part 2 wing installation – Summers 84' Superroller User Manual
Page 21
SECTION 2 - ASSEMBLY
Part 2 Wing Installation.
P2W1. Position the left hand part 2 wing as shown. Install pin and hardware shown in Figure 5.
Note the orientation of the pins, the cross hole should be towards the outside of the bush-
ing.
P2W2. Raise the rear of the part 2 wing in the air high enough to allow the roller to be placed under
the frame.
NOTE: An H has been stamped onto one end of each roller. Position the center
roller with the H to the left. All other rollers should have the H positioned to the center of the
machine.
P2W3. Install bearings with the grease zerk toward the rear of the machine. Secure to bolt plates
with the hardware shown in Detail B of Figure 5. Install reinforcement angles between the
bottom attachment holes on the inside of the bolt plate, as shown in Detail B of Figure 5.
Install snap rings on each roller shaft. Ensure that the roller is centered in the bearings and
tighten the set screws.
P2W4. Install 8P7150LB as shown in the diagram, attach with the pins and hardware shown. Note
the orientation of the pins.
P2W5. Install the hydraulic cylinder as shown. Install the pins and washers as shown in Detail A of
Figure 5 on both the top and bottom of the cylinder.
Repeat the above steps for the right hand part two wing.
2-11
1. Install snap rings on each roller shaft. Ensure that the roller is centered in the bearings
and tighten the set screws.
P1W6. Install the hubs on 8P6100 as shown in Detail C of Figure 4. Attach with the shown hardware
and tighten.
P1W7. Install the tires to the hubs installed in the previous step. Tighten the wheel nuts to 170 ft-
lbs. torque.
P1W8. Loosely position 8T4100 on the wing frame and affix the hardware associated with 8T4100.
Do not tighten the fasteners.
P1W9. Position 8P6100 as shown in the diagram, making sure the assembly is centered to the
clevis on wing frame. Install 8P3640 and secure with the hardware shown in the diagram.
P1W10. Install the hydraulic cylinder as shown. Install the pins and washers as shown in Detail B
in Figure 4 on both the top and bottom of the cylinder.
Repeat the above steps for the Right hand side of the machine.