Videoswitch VM - Manual (Page 16)

VM-Series Multiplexer User Manual 20/02/2002 12:00
Videoswitch
16 VM601h.doc
Status Info The status information may be displayed anywhere
on the screen. Use
п р с т. Press BACK to
finish.
Text Style The style of all text character may be selected for
optimum clarity and personal preference. Use
с т.
Press BACK to finish.
Alarms/Activity Detection
Activity Detection
Camera 1,2,3 etc Select the required camera using с т, then press
ENTER to continue or BACK to finish.
Zones Select which parts of the image you wish to be
monitored for activity. Use
п р с т and
SELECT. PLAY will turn all zones on or off. Press
BACK to finish.
Test The activity detection is tested here. Use с т to
select sensitivity and п р to select what area of
the screen must have activity in order to trigger an
alarm, as shown by “AL” on the screen. Press BACK
to finish.
Daily Timers Timer may be set for each day of the week to control
when activity detection or alarm contact inputs are
active.
Monday, Tuesday etc Select the required day using с т, then press
ENTER to continue or BACK to finish.
Start Time Set the start time for this day of the week. Use
п р с т and SELECT. Press BACK to finish.
End Time Set the end time for this day of the week. Use
п р с т and SELECT. Press BACK to finish.
Activity Enabled Activity detection may be enabled, disabled or
controlled by the daily timers. Use
с т. Press
BACK to finish.
Alarm Input Enabled Alarm inputs may be enabled, disabled or controlled
by the daily timers. Use
с т. Press BACK to finish.
Alarm Input Polarity Alarm inputs may be set as normally open or
normally closed. Use
п р с т SELECT. Press
BACK to finish.
Pull-Up on Alarm/Activity
Full Screen Pull-Up Specify whether you want alarms to pull up a full
screen image. Use
с т. Press BACK to finish.
Pull-Up Hold Time Specify how long you want a pulled-up full screen
image to be held before anything else can be
displayed. Use
с т. Press BACK to finish.
Pull-Up Sequence Dwell Time Specify how long you want each pulled-up full screen
image to be held when cycling between more than
one alarmed camera. Use
с т. Press BACK to
finish.
Preset on Alarm/Activity
Alarm Relay Hold Time Specify how long you the alarm relay to stay
energised when alarms have cleared. The alarm time
lapse mode is also selected while the relay is
operating. Use
с т. Press BACK to finish.
Dome/Receiver Type Specify the type of dome or receiver that is to be
controlled by twisted pair. Dome types may not be
mixed, but any dome type may be mixed with coax-
receivers. Use
с т. Press BACK to finish.
Coax Receivers Specifiy which cameras, if any, have VR receivers
using coax telemetry control. Use
п р с т
SELECT. Press PLAY to toggle all on or off. Press
BACK to finish.
Receiver/Dome Setup Note that some options do not apply to certain
domes.
Camera 1,2,3 etc Select the required camera using с т, then press
ENTER to continue or BACK to finish. Use с т.
Press BACK to finish.
Configure Receiver/Dome