AMETEK 7330 Pro-Stik II - Manual (Page 3)

3
Accessories
(Purchased separately)
(a) Compression Fitting, 5/8” to ¾” NPT, Stainless Steel
(b) Adapter Bushing, 2” NPT to ¾” NPT, Stainless Steel
(c) A 2 inch, 316 Stainless Steel float.
(d) A 316 SS Spacer to insure the float-magnet is
always in the active span.
(e) A 316 SS “E-Clip” to hold float on to the probe.
(f) ECTFE (Ethylene Chlorotrifluoroethylene) 2 piece
Halar® end cap with spacer. A plastic end cap is
recommended when probe is resting on the bottom
of a metal tank.
Halar® is a Registered Trademark of Ausimont USA, Inc.
Installation of a Rigid Probe
Installation of Stainless Steel Probe
1. Insert bottom end of probe into tank.
Do not allow the float to drop suddenly since it can
damage the retainer at end of probe.
2. Thread bushing into tank or flange. Bolt flange into
position.
3. Thread compression fitting into bushing or flange.
4. Hand tighten. To insure compression fitting is
sealed, turn fitting ¼ turn after hand tightening.
Make final check to see that all bolts and screws are in
proper position and probe is securely tightened.
Installation of Flex Probe
Special instructions are provided for the installation
of PVDF probes. See the Flex Probe Installation &
Handling Procedure document Z190.
(a)
(b) (c)
(d) (e)
Installation of Accessories
1. The normal sequence for assembly of the probe is
as follows:
a. Slide on compression fitting (a) for Style S, M or
R probe.
OR
b. Slide reducing bushing (b) or flange (customer
supplied) on for Style D probe.
2. Slide float (c) onto probe. Magnet is located in
middle of 316 SS float, so orientation of float does
not make any difference.
3. Slide spacer (d) onto the tube.
4. Capture all of these parts with E-Clip (e) or ECTFE
end cap (f). The Halar® end cap is held in place by
the retainer.
(f)
Spacer Retainer End Cap