ARI Armaturen ARI-PACO 1,6kN EN - Manual (Page 7)

0040506001 1811 Page 7
Operating and installation instructions
Electric thrust actuator ARI-PACO 1,6 kN
4.4 Technical data - Remarks
Type ARI-PACO
Thrust kN 1,6 D 1,6 Y
Travel max. mm 30
Control speed mm/sec. 0,15
Motor voltage ( ±10% ) 230V - 50H 24V - 50Hz
Control signal (input) Three-step signal
0 - 10 V DC
(invertable, max. 0,5 mA)
Feedback signal (output) --
0 - 10 V DC
(invertable, max. 5 mA)
Power consumption VA 8,0 11,5
Operation mode S3 50% cyclic duration factor
Enclosure IEC 60529 IP 54
Max. operative ambient temperature 0 °C ... +50 °C
Handwheel Change-over switch and handwheel
Mounting position Horizontally to vertical above the valve body (any position 90° from vertical)
Stem lubricant Chesterton: Anti-Seize-Nickel
Weight kg 3,4 3,5
* Control speed and power consumption are 20% higher at frequency of 60 Hz.
Accessories
Additional torque switches
2 changeover contacts, potential-free,
switching capacity 3A, 250 V~
2 changeover contacts, potential-free,
switching capacity 3A, 250 V~
Switch board
(optional as 2 add. torque switches or
1 error message switch usable)
-- --
Potentiometer 1 pc. - 100 or 1000 Ohm --
Additional voltages/frequencies 24V - 50Hz --
* Control speed and power consumption are 20% higher at frequency of 60 Hz.