ARI Armaturen ARI-PACO 1,6kN EN - Manual (Page 20)

Page 20 0040506001 1811
Operating and installation instructions
Electric thrust actuator ARI-PACO 1,6 kN
7.0 Care and maintenance
The linear actuator requires little maintenance, so that no maintenance is required at fixed
time intervals.
Depending on conditions of use, the maintenance and the repair intervals should be
determined by the operator.
The linear actuator may not be cleaned with high-pressure devices or with solvents of
cleaning materials that are aggressive, harmful to health or easily flammable.
During or after cleaning, the sealing elements of the linear actuator should be carefully
examined.
If there is any sign of a lubricant leak or contamination, the sealing elements should be
repaired.
8.0 Troubleshooting
In the event of malfunction or faulty operating performance check that the installation and
adjustment work has been carried out and completed in accordance with these Operating
Instructions.
If malfunctions cannot be eliminate with the help of the following table
“9.0 Troubleshooting table”, the supplier or manufacturer should be consulted.
12. Adjust actuating directions switch according to valve function to (+) or (-) (in some
cases, an inverted direction of action is required).
13. Reinstall housing and release the black button for manual actuating.
14. Execute function tests.
-
ATTENTION !
- It is essential that the safety regulations are observed when identifying faults.