Ordering information – Red Lion PSC User Manual
Page 7
7
ORDERING INFORMATION
Note: Output Modules are NOT supplied with the controller. When specifying the controller, be sure to
purchase the appropriate output module for the Main Control Output and if necessary, the alarm output(s)
and secondary output. The controller can be fitted with any combination of output modules that do not
have the RS485 option.
The Logic/SSR Drive Module is a switched DC source, intended to drive the DC input of an SSR power
unit. It should never be connected to a line voltage.
All modules are shipped separately and must be installed by the user.
MODEL NO DESCRIPTION
Type 4X/IP65
BEZEL
4 to 20 mA
ANALOG
OUTPUT
0 to 10 VDC
ANALOG
OUTPUT
ALARM
OUTPUTS
SECONDARY
OUTPUT
RS485 COM
PART
NUMBER
PSC
Process
Setpoint
Controller
YES
YES
NO
2
NO
NO
PSC11001
YES
YES
NO
2
NO
YES
PSC11004
YES
YES
NO
1
YES
YES
PSC11005
YES
NO
YES
2
NO
YES
PSC12004
YES
NO
YES
1
YES
YES
PSC12005
Relay Module
OMD00000
Triac Module
OMD00001
Logic/SSR Drive Module
OMD00003
PMK5
Panel Mount Adapter Kit (1/4 DIN to 1/8 DIN)
PMK50000
RLY
45 A Single Phase Panel Mount SSR
RLY50000
25 A Single Phase DIN Rail Mount SSR
RLY60000
40 A Single Phase DIN Rail Mount SSR
RLY6A000
25 A Three Phase DIN Rail Mount SSR
RLY70000
These models have dual alarm outputs, or single alarm with secondary outputs, with shared common terminals (Form A Type). As a
result, these outputs should be fitted with the same type of output module. The main output (OP1) may be fitted with any type of output