Red Lion CSSG - Manual (Page 6)

6
LEDS
STS – STATUS LED
The Status LED is a dual color LED that provides information regarding the
state of the module. This includes indication of the various stages of the start-up
routine (power-up), as well as any errors that may occur.
Startup Routine
Error States
OP1, OP2, OP3, – OUTPUT STATUS LED
The OP1, OP2, andOP3 LEDs are factory configured to indicate the status of
the outputs. The LEDs turn on when the output is active.
These LEDs may be remapped to various other module properties.
ALM – ALARM LED
The Alarm LED is factory configured to indicate the presence of an alarm.
Whenever one of the seven alarms is active, the LED turns on.
This LED may be remapped to various other module properties.
FIRMWARE UPGRADE
The module’s firmware is stored in flash memory to prevent software/hardware
conflicts, and so that software features may be added in the future.
During a download, Crimson compares its own library of firmware files with
those stored in the Master module. If they do not match, Crimson will download
the necessary files. The Master then checks to make sure that the I/O modules
contain the same firmware. If they contain a different revision, the Master will
automatically copy those files into the module's flash memory. During this
process, the module LEDs will flash rapidly, starting with the top row, and
progressing through the remaining rows until the process is complete.
CONFIGURATION
Programming is done via Crimson ® software, a Windows ® compatible
configuration interface. Please see the Crimson manual for more information.
Rapidly Flashing Red
Module is currently running the boot loader and/or
being flash upgraded by Crimson. This occurs for
four seconds during a power up.
Steady Red Module switching to configuration.
Green Module performing normally.
Module is controlling properly, but has lost
communication with the Master.
Green/Pulsing Red
Module not controlling, and not communicating. Solid Red
ORDERING INFORMATION
Single Loop, Two SG Inputs, Relay Outputs, Analog Out
Programming Cable for CS, G3, & Paradigm Series
Crimson ® Programming Software 2
Single Loop, One SG Input, Solid State Outputs, Analog Out
Single Loop, Two SG Inputs, Solid State Outputs, Analog Out
Communications Cables 1
Crimson ® Programming Software, Manual, and Download Cable
Rail Stops (Qty 2)
Replacement Base
Replacement Termination Plug
CSSG1 1
CBL
Software
Accessories
CSSG10RA
CSSG11RA
CBLPROG0
SFCRM
CSSG10SA
CSSG11SA
CBLxxxxx
SFCRK
RSRSTP00
CSBASE00
CSTERM00
Modular Controller Master, Multi Comms ports and Ethernet
CSMSTR Master Module
CSMSTRGT
CSMSTRSX
CSMSTRV2
DESCRIPTION MODEL NO. TYPE PART NUMBER
Strain Gage
Control Modules
Communications
Cables
(10 feet)
1 Visit www.redlion.net for a complete list of PID modules, data acquisition modules, communications drivers and cables.
2 Free at www.redlion.net
Single Loop, One SG Input, Relay Outputs, Analog Out
Modular Controller Master with multiple protocol converter, data
logger, web server with Virtual HMI up to QVGA (320 x 240) size
and expansion slot.
Modular Controller Master with multiple protocol converter, data
logger, web server with Virtual HMI up to VGA (640 x 480) size
and expansion slot with increased SDRAM