Red Lion CSSG - Manual (Page 4)

WIRING
WIRING CONNECTIONS
All conductors should meet voltage and current ratings for each terminal. Also, cabling
should conform to appropriate standards of good installation, local codes and regulations.
When wiring the module, use the numbers on the label to identify the position number with
the proper function. Strip the wire, leaving approximately 1/4" (6 mm) of bare wire exposed.
Insert the wire into the terminal, and tighten.
4
1
7
13
Terminals 13 to 18
Terminals 7 to 12
Terminals 1 to 6
HARDWARE
ANALOG OUTPUT OPTION
Select either Voltage or Current output by placing the output jumpers in the
appropriate location. The output jumpers are located on the side of the CSSG1 module.
Current Voltage
5
ATTACH THE MODULE BASE
TO THE DIN RAIL
4
3
1
2
ATTACH MODULE TO BASE
INSTALLATION
SEPARATE BASE
FROM MODULE
SG MODULE BASE
SG MODULE BASE
COM.
4 3 1 2 5
+SIG. -SIG. +EXC COM.
6
-SIG.
OP3 COM.
13
OP1 COM.
ANALOG- OP3 N.C. OP3 N.O. ANALOG+
OP2 + OP1 + OP2 COM.
(OPT.)
2 1
8 7 9
+SIG.
10 11
+EXC
12
(OPT.)
2
15 14
N/C
16 17 18