Bondioli&Pavesi 399CEEG01_D User Manual

Page 23

ENG

G9 SHIELD ASSEMBLY

Grease the bearing groove on inner yokes.

Fit the bearing ring into the yoke groove with the grease fitting facing the

drive tube.

Install the outer cone, inserting the grease fitting through the proper hole.

Install the base cone and shield tube.

Tighten the Philips head screws.

Use of electric powered screwdrivers is not recommended.

CV JOINT SHIELD DISASSEMBLY

Remove the screws arranged radially around the circumference of the CV

cone.

Remove the screws from the base cone.

Remove the base cone and the shield tube.

Remove the CV cone.

Disengage the retaining spring, leaving it inserted in one of the two holes of

the bearing ring to avoid losing it.

Spread the bearing rings and remove from their groove.

CV JOINT SHIELD ASSEMBLY

Grease the seats and install the shield support bearings.

Fit the bearing ring onto the inner yoke with the reference pin facing the

drive tube.

Install the bearing ring on the CV body with the reference pins facing the

inner yoke. The bearing ring is equipped with a grease fitting, used only for

50° CV joints. This grease fitting is not used with 80° CV joints.

Connect the retaining spring to the two edges of the bearing ring.

Insert the shield aligning the radial holes with the reference pins of the bearing

ring and the hole on the bottom with the reference pin of the small bearing.

The grease fitting of the bearing must be aligned with the holes on the shield.

Check that the radial holes in the shield are aligned with the holes in the

reference pins of the bearing ring and that the reference pin is inserted.

Tighten the 6 flanged screws of the shield. Use of an electric screwdriver is not

recommended.

Fit the base cone with the tube, inserting the reference pin of the bearing in

the hole provided in the base cone. The grease fitting of the bearing is in the

hole of the base cone.

64
65
66
67

70
71
72