HighPoint RocketRAID 2224 - Manual (Page 31)

HighPoint Technologies, Inc.
Modify a Scheduled Task
This command is used to change settings for a scheduled task. To Modify a Task Schedule:
1. Select a task from the Task schedule list.
2. Click the “Modify” button on the toolbar, and modify the task settings in the pop-up window.
Delete a Scheduled Task
This command is used to delete a Scheduled Task for the selected remote system. To delete a Task
Schedule:
1. Select a task from the Task schedule list.
2. Click the “Delete” button on the toolbar.
10 - Configuring Remote Systems
Then HighPoint RAID Management Console manages a RAID controller through a connection to the
HighPoint RAID Management Service, which runs on the system where the RAID host adapter is
physically installed. This type of system is referred to as a “remote system”.
Note: What the software classifies as a “remote system” may not always be an actual remote computer. In
some configurations, the local computer hosts both the RAID host adapter and Management Service. The
local system, in these cases, is still generically referred to as a “remote system”.
Add a Connection
This command is used to add new connection to a remote system. To Add a Connection:
1. Highlight the “File” menu, and select the “Remote Control” function.
2. Click the Add button on the toolbar or select the “Add” command from the “Operation” menu.
3. Enter the system address, name, and port information in the pop-up window.
The system address can be a host name, or an IP address. The default system port is 7402.
4. Click “OK” to finish adding the new connection.
27