HighPoint RocketRAID 2320 - Manual (Page 55)

1 - Red Hat Enterprise 3 Overview
This section provides instructions describing how to install and utilize the
RocketRAID 2320 Adapter on a Red Hat Enterprise 3 Linux system.
2 - Installing Red Hat Enterprise 3 (AS, ES, WS) Linux on the
RocketRAID 2320 controller
To install Red Hat Enterprise Linux onto disks or RAID arrays attached to
RocketRAID 2320:
Step 1 Prepare the Driver Diskette
The driver is provided in a floppy diskette image file format.
On a DOS or Windows system, a driver diskette can be generated using rawrite.exe.
This utility is included on the Red Hat Enterprise Linux CD (under /dosutils). Run
rawrite using a command prompt window, and follow the directions it provides.
On a Linux system, use the “dd” command to generate a boot diskette. Insert a
floppy disk into the floppy drive and type the following command (amd64 driver for
example):
# dd if=rh3dd-amd64.img of=/dev/fd0
Step 2 Install Red Hat Enterprise Linux
Start installing Red Hat Enterprise Linux by booting from the installation CD.
At the “Welcome to Red Hat Linux” installation screen, a prompt labeled “boot:”
will appear at the bottom of the screen. Type in linux dd, then press Enter.
boot: linux dd
When prompted “Do you have a driver disk?”. Select “Yes”.
When prompted “Insert your driver disk and press OK to continue”, insert the
driver diskette into the system’s floppy drive, and select “OK”.
Linux Driver Support
5-5