HighPoint RocketRAID 2320 - Manual (Page 51)

1 - Fedora Core 3 Linux installation Overview
This section provides instructions describing how to install and utilize the
RocketRAID 2320 Adapter on a Fedora Core 3 Linux system.
2 - Installing Fedora Core 3 on the RocketRAID 2320 Host Adapter
Note: If the OS is running kernel that differs from the one supported by the
precompiled driver, the precompiled drivers cannot be used. A driver can be built
for this kernel using the OpenSource package for the RocketRAID 2320 controller.
This package is available from our website, and is posted on the BIOS/Driver page
for the RocketRAID 2320.
To install Fedora Linux onto hard disks or RAID arrays attached to RocketRAID 2320
controller, follow the steps outlined below:
Step 1 Prepare the Driver Diskette
The driver is contained in a floppy diskette image file.
On a DOS or Windows system, a Fedora driver diskette can be generated using
rawrite.exe. This utility is included on the Fedora Linux CD (under /dosutils). Run
rawrite using a command prompt window, and follow the directions it provides.
On a Linux system, use the “dd” command to generate a boot diskette. Insert a
floppy disk into the floppy drive and type the following command:
# dd if=fc3-i386.img of=/dev/fd0
Note: The driver disk image file depends on your core version and hardware.
Step 2 Install Fedora Linux
Installation steps for Fedora Core 3
1) Boot from the Fedora Installation CD, and start the install procedure.
Linux Driver Support
5-1