HighPoint RocketRAID 4460 - Manual (Page 14)

Hardware – Description and Installation
14
6. Close and secure the system chassis.
3 - Verifying Installation
Once the RocketRAID 4460 host adapter and hard disks have been installed into the
chassis, boot-up the system to verify that the hardware is properly recognized.
1. Power on the system. If the system detects the presence of the adapter, the
RocketRAID 4460 BIOS Utility will be displayed during bootup.
2. Press Ctrl+H to access the RocketRAID 4460 BIOS Utility.
The BIOS Utility will display information about hard disks attached to the adapter.
Make sure all attached disks are detected by this utility. If any of the hard disks are
not detected, power down the system and check the cable connections to both the
card, and enclosure.