HighPoint RocketRAID 4460 - Manual (Page 13)

Hardware – Description and Installation
Note: Make sure the system is powered-off before installing the RocketRAID 4460
host adapter.Be sure of the cache memory module is present and seated firmly in
the DIMM socket (DDR2-533) for RocketRAID 4460.
default 1GB of ECC DDR2- 533 SDRAM. User can upgrade to 2GB or 4GB
DDR2 module.
2. Open the system chassis and locate an unused PCI-E x8.
3. Remove the PCI slot cover .
13
BEEP1 – Speaker
Alarm (speaker): the speaker emits and audible alarm in the case of disk/array failure.
Ethernet Port
Ethernet port(J4) for Out of Bound Manegement, support Net Time Protocol.
Cable – Internal Mini-SAS to Mini-SAS
The integrated RocketRAID 4460 includes 6 Internal Mini-SAS to Mini-SAS cables.
4. Gently insert the RocketRAID 4460 into the PCI-E slot, and secure the bracket to
the system chassis.
5. After installing the adapter, attach the Mini-SAS connectors to the RocketRAID
4460’s Mini-SAS port,and to chassis backplane. Each Mini-SAS cable supports
up to 4 hard disk drives. Consult the chassis’s manual for proper installation
procedures.
1. Check/Upgrade Memory Module before installing the RocketRAID 4460 Host
Adapter.The RocketRAID 4460 controller include one DIMM socket with
Below table show the specification of supported DDR2 module.
2 - Installing the RocketRAID 4460 Host Adapter
Density SPEED DDR DIMM module Type Chip data width Number of RANK
1GB, 2GB, 4GB 533Mhz capable DDR2, 240Pin, ECC, Unbuffered or Registered X8 or X16 1 or 2