HighPoint RocketRAID 2740 - Manual (Page 61)

61
4) The driver will be installed to system. Click “Restart” to restart the system.
After the system is restarted, you can use a web browser to configure the controller and setup
RAID arrays, and use MacOS X Disk Utility to create partitions on the RAID arrays.
3 - Installing Web RAID Management Software
HighPoint Web RAID Management Software is used to configure and keep track of your
hard disks and RAID arrays attached to the controller. Installation of the web management
software is optional but recommended.
Please refer to HighPoint Web RAID Controller Management Software documents for more
information.
4 - Web RAID Management Interface
Note: To use the web-based RAID management interface, a web browser with XML support
is required, e.g. Safari 2.0, Internet Explorer 6.0, Mozilla or FireFox.
To run the management interface, start your browser and enter the following URL address:
https://localhost:7402
If you are managing a remote system please change "localhost" to the server’s host name or
IP address. If you can't connect to local system, please check if a process named raidman-httpsd is
running on the system. If it is not running, you can start it manually by running the command
“SystemStarter start raidman” from terminal.
If you can't connect to a remote system, check if raidman-httpsd is running on that system