Operating commands, P outputting one single message, Bp continuous outputting – Vaisala PTB210 (serial) User Manual
Page 19: Unit selecting a pressure unit
Chapter 4 ________________________________________________________________ Operating
VAISALA _______________________________________________________________________ 17
Operating Commands
.P Outputting One Single Message
.P
The command outputs the latest multi-point corrected pressure reading
with two decimals.
.P
1012.99
.BP Continuous Outputting
.BP
The command outputs the MPC corrected pressure reading
continuously. The output interval depends on the measurement rate
and the averaging. The outputting is stopped by pressing enter key
(
.P
997.99
998.01
998.01
...
998.02
(command invisible)
.UNIT Selecting a Pressure Unit
.UNIT.x
x = 0 (hPa)
6 (kPa)
1
(mbar)
7
(Pa)
2
(inHg)
8
(mmH
2
O)
3
(psia)
9
(inH
2
O)
4
(torr)
10
(bar)
5
(mmHg
As default, the unit is 0.
NOTE
To activate the new setting, please remember to reset the barometer
with the command .
RESET