Lower half of display, Selecting analog outputs – Vaisala HMT360N User Manual
Page 52
User's Guide ______________________________________________________________________
50 __________________________________________________________________ M210744EN-C
Lower Half of Display
The output quantities metric/non metric DIP switch can be used to
select between °C and °F.
It is possible to check the pressure setting of the transmitter by pressing
button Dn. To return to the temperature reading, press button Dn again.
Selecting Analog Outputs
You can select the output quantities for channels 1 and 2 by turning the
Calibration Enabled/Disabled DIP switch of the transmitter to
position Enabled (up) and the three output selection DIP switches to
position special (all up).
Press button C on the display cover: text "SCAL" appears on the
display. Then press button E until the following display appears:
0505-288
The characters on the second line of the display in this menu correspond
to the quantities according to the table in section
Select the quantity for Ch 1 with buttons Up and Dn and acknowledge
the selection with button E.
If the transmitter is equipped with two analog channels, select the
quantity for Ch 2 in the same way, for example:
A
water content
w
mg/m
3
lb/MMscf
Character
Quantity
Abbreviation
Metric Unit
Nonmetric Unit