Vaisala HMP42 User Manual
Page 72
HMI41 AND HMP42
Operating Manual
M210317EN-A
68
NOTE
The HMI41 setup contains further settings (start, baud,
seri and calib) that appear after probe type setting when
pressing ENTER. Start setting is changed only when
using the HMP44/L probes (
START
5, see the HM44
Operating Manual). For calib, see the operating manual.
Other settings are meant for the HMI41 used as a field
calibrator for Vaisala humidity transmitters. Do not
change them. Press ON/OFF after probe type setting.
This manual is related to the following products: