Posey Wheelchair Wing-Backs - Manual

Posey Company • 5635 Peck Road, Arcadia, CA 91006-0020 USA
Phone: 1.800.447.6739 • Fax: 1.800.767.3933 • Web: www.posey.com
© 2009 Posey Company. All rights reserved.
Seating and PoSitioning Quality Products since 1937
Posey
®
Wheelchair Wing-Backs
These side lateral supports help provide a vertical side support
surface for patients who lean laterally. The angle of attachment
may be adjusted manually to accommodate the needs of the
individual patient/ resident. Made of 1/4” (1 cm) plywood base covered with
foam and a vinyl cover. The Posey Wheelchair Wing-Backs install in seconds
using the existing screws from the wheelchair back upholstery.
• Meets CA #117 flame retardancy standards.
• Mounting hole spacing, 5¼” (13 cm)
• One pair per package.
REF
6321 8”W x 10”L (20 cm x 25 cm)
M1638 051209
INSPECTION
Inspect before each use: check for broken stitches;
or torn, cut or frayed material. DO NOT use soiled or damaged
products.
DISPOSAL
Properly dispose of the product per facility’s policy for
BIOHAZARDOUS materials.
STORAGE AND HANDLING
This device is designed for use in normal indoor environments.
This device may be stored in ambient warehouse temperatures at
normal humidity levels. Avoid excess moisture or high humidity
that may damage product materials.
CLEANING INSTRuCTIONS:
• Wipe Clean with mild detergent. OSHA approved
intermediate level disinfectants can be used per
manufacturer instructions. DO NOT use phenol and
benzyl based disinfectants.
• After cleaning, products MUST be rinsed with water to remove
any residual chemicals.
• Make sure products are completely dry before use.
WHEELCHAIR WING-BACkS
APPLICATION INSTRuCTIONS:
1. Remove the top two screws on each side of the wheelchair backrest.
2. Orient the Wing-back so that the screw holes in the metal
brackets line up with the screw holes of the wheelchair back
post. The Wing-back should be positioned so that it is above the
wheelchair armrest.
3. Attach the screws so that the seat back and the Wing-back are
both secure.
The angle of the Wing-back may be adjusted by applying pressure
to the metal bracket and bending it slightly. To avoid damaging
the Wing-back, be sure to brace the whole product with your hand
before applying pressure to the metal bracket.
MONITORING
Always follow your facility’s policies and procedures for
patient assessment, monitoring and rehabilitation
LATEX