Posey Deluxe Lateral Arm Support - Manual

• Wipe Clean with mild detergent. OSHA approved
intermediate level disinfectants can be used per
manufacturer instructions. DO NOT use phenol and
benzyl based disinfectants.
• After cleaning, products MUST be rinsed with water to remove
any residual chemicals.
• Make sure products are completely dry before use.
Quality Products since 1937
ApplicAtion instructions:
1. Orient the armrest so that the long foam panel fits inside the
wheelchair seating area to help support the patient laterally
(See photo for proper orientation).
2. Place the cut-out foam slot of the Elevated Armrest over the
wheelchair armrest and press down into position (fig. 1).
3. Remove the adhesive backed hook tab from the inside panel of
the Elevated Armrest and place it on the inside of the armrest
panel.
4. If desired, the positioning straps may be opened and used to
secure the patient’s arm position. Alternatively, the positioning
straps can be left closed and the patient’s arm may rest on top
of the straps. A towel can be draped over the vinyl, if desirable.
6320
Posey
®
Deluxe Lateral Arm Support
SEATING & POSITIONING
cleAning instructions:
The Deluxe Lateral Arm Support is designed to help prevent
lateral leaning. It also provides a convenient elevated armrest
to facilitate arm use and rehabilitation. Made of padded
foam covered with vinyl. Convenient, ambidextrous design – one
product fits either side of a wheelchair armrest. Meets California #117
Flame Retardancy Standards. One per package.
REF 6320 Lateral Arm Support 16”L x 7”W (41 cm x 18 cm)
Posey Company • 5635 Peck Road, Arcadia, CA 91006-0020 USA
Phone: 1.800.447.6739 • Fax: 1.800.767.3933 • Web: www.posey.com
MDSS GmbH
Schiffgraben 41
D-30175 Hannover, Germany
EC REP
M0910 050109
© 2009 Posey Company. All rights reserved.
DeluXe lAterAl ArM support
storAge AnD HAnDling
This device is designed for use in normal indoor environments.
This device may be stored in ambient warehouse temperatures at
normal humidity levels. Avoid excess moisture or high humidity
that may damage product materials.
inspection
Inspect before each use: check for broken stitches;
or torn, cut or frayed material. DO NOT use soiled or damaged
products.
DisposAl
Properly dispose of the product per facility’s policy for
BIOHAZARDOUS materials.
Monitoring
Be sure to follow your facility’s policies and guidelines
for frequency of patient monitoring.
LATEX
Fig. 1