Posey Soft Split Side Rail Protectors - Manual

1 2
$
%
Fig. 2
Fig. 3
Posey Split Side Rail Protectors feature a universal design with
multiple versatile hook and loop straps for easy attachment to
many beds and side rails. The soft, padded design helps protect
against hard side rail surfaces and is covered in a water repellent
vinyl that can be wiped clean between uses. Provides a visual
deterrent against patients exiting the bed between the side rails and
depending on the bed system, these protectors may help mitigate
and safeguard against FDA/HBSW entrapment zones 1 and 5 1 . Meets
CA #117, Section E Flame Retardancy Standards.
REF
5705 For older, open bar side rail designs,
36”L x 16”H x ½”thick (91 cm x 41 cm x 1 cm)
REF
5705LS For newer, encapsulated side rail designs,
36”L x 16”H x ½” thick (91 cm x 41 cm x 1 cm)
(Two more upper straps than model 5705. All four
upper straps are longer than model 5705)
Monitoring
Posey Split Side Rail Protectors will not prevent a
determined patient from exiting the bed, going over or attempting
to go between or through side rail gaps. DO NOT articulate bed if
product is applied. ALwAyS follow your facility’s policies and
procedures for patient assessment, monitoring and rehabilitation.
Application Instructions:
1. Inspect product prior to use. DO NOT use soiled or damaged
products.
2. Place the pad inside and between the upper and lower side rails of
the bed with the attachment straps pointing outward (Fig. 1).
3. Secure the bottom attachment straps to the bed frame. At least
two of the three straps need to be secured for proper use.
4. Position and attach the remaining straps to the bed side rails by
(Fig. 2):
A. Wrapping the loop closure completely around the attaching
point;
B. Pulling the hook material over the loop material;
C. Excess strap length may be cut if desired.
5. While not all straps may be applicable for use on some bed
models, ensure that enough of the straps are attached to secure
the pad on the bed (Example of a properly installed 5705 shown
in Fig. 3).
6. Check for proper fit. Modified beds may not be compatible with
Posey Split Side Rail Protectors.
Cleaning Instructions:
Wipe clean with soap and water or disinfectant.
DO NOT use cleaners that contain Phenol or Benzyl.
A
Disposal
Properly dispose of the product
per facility’s policy for BIOHAZARDOUS
materials.
Storage And Handling
This device is designed for use in normal indoor
environments. This device may be stored in
ambient warehouse temperatures at normal
humidity levels. Avoid excess moisture or high
humidity that may damage product materials.
$
%
Fig. 1
C B
5705LS
© 2010 Posey Company. All rights reserved. M1628 REV B 071810
Posey Company • 5635 Peck Road, Arcadia, CA 91006-0020 USA • www.posey.com
Phone: 1.800.447.6739 or 1.626.443.3143 • Fax: 1.800.767.3933 or 1.626.443.5014
1
Guidance for Industry and FDA Staff - Hospital Bed System Dimensional and Assessment Guidance to Reduce Entrapment, March 10, 2006.
Posey
®
Split Side Rail Protectors
Bed SAFety