Sol Transit Shelter Ad Light - Manual (Page 8)

8 rev. 0512 MKTG-IM-TOLAR-TSAL-BACK TO BACK-003
Installation and Owner’s Manual | TSAL B2B Series
3.0 INSTALLATION
3.1 Installing the Solar PV Arrays (using PV Panels)
1. Lay the solar array(s) on a protected surface with the solar array junction box toward you. The
cardboard shipping carton can be used to provide a protected surface while you install the mounting
angles.
2. Depending on the solar array size of your system, there may be one, two, or three solar panels per
shelter. Make sure to check your array size.
3. There should be one PV harness per shelter with corresponding mc connectors for each solar array.
3.2 Installing the Solar PV Arrays and Attaching Angles (using PV Panels)
1. Do not place screws in the areas where the solar array mounting legs will be placed Place the solar
array mounting angles on the edge of the solar array, so that the bottoms and sides of the solar array
are covered, as in Figure 4.
2. Make sure the pre drilled holes in the mounting angle are on the sides of the solar array. Center the
solar array so that there are equal reveals of the mounting angle on each end of the array.
3. Using the #14 X 1” TEK screws provided attach the mounting angles to the solar array.
Do not place screws in the areas where the solar array mounting legs will be placed.
FIGURE 3 SOLAR ARRAY SYSTEM
FIGURE 4 SOLAR PANEL MOUNT
Mounting Angle
Solar Panel