Rosendahl bonsaiDRIVE - Manual (Page 27)

- 52 -
MENU 091 FIRMWARE
In menu 091 you can see the actual firmware version installed.
BF 00.52 is the firmware being described in this section.
To make a firmware update, hold down the [RECORD] key and press
the [
◄ ] key. See details in chapter 10 "Firmware update" in the main
part of this manual (I, page 22).
Each time the bonsaidrive is powered up a checksum of all flash
memory cells will be calculated. Thus flash memory errors will be
detected and reported as bonsaidrive errors 030 and 031.
MENU 092 HARDDISK INFO
The menu 092 gives information about the hard drive.
In the top line is shown the name and number of the hard drive. In
the second line the total capacity in GBYTE is shown.
(GBYTE = Gigabyte)
Underneath is shown how many clips have been recorded and how
much storage space has been used.
The difference between the disk capacity and the storage space used
is the storage capacity remaining for recording.
One hour uses about 50 Gbyte storage dependant of the video
material.
The number of disk errors that have occured since the last time the
machine was switched on is shown in the bottom line. This value
should always be zero.
MENU 099 SAVE AND POWER DOWN
Press the [
■ ] key to save all menu settings and put the bonsaidrive in
power down mode.
Use menu 009 SAVE CLIP INFO TO DISK to store modified locator
points, time code offsets and time code format in the clip info area on
the hard drive before powering down.