Pop & Lock PL8350 - Manual (Page 2)

harness from moving.
13. Mount the Relay kit on a suitable location near the battery.
14. Attach the long wiring harness to the relay harness by attaching the green to green and blue to brown
wires.
15. Run the purple and gray wire bundle through the firewall of the truck. Please try to follow the OEM
wiring routes if possible.
16. Locate the Tan with White stripe and Tan with Green stripe wires in the drivers side kick panel
in the larger wiring harness.
17. Install a blue connector tap on each wire and slide the purple and the gray connectors over the blue
connector taps.
18. Attach the relay harness to the battery by connecting the fused lead (red) to the positive terminal and
the black lead to the negative terminal.
19. Test the POWER LOCK by locking and unlocking the power door locks. If the POWER LOCK is in
reversed order to the vehicle power lock, then reverse the purple and gray wires under the dash.
20.Re-install the access panel on the tailgate and the tailgate bed-liner if applicable.
For Tech Support call: 1-800-342-5911 2 of 2
Diagram 2 - Assembled View
Slide Bolt
OEM Plastic
Locking Arm
8 MM Mounting Nuts
12-27-11