Night Owl NODVR108-500GB - Manual (Page 60)

59
Changing the Network Settings on the DVR
Use the information that you just wrote down for the next steps.
To access the LAN Menu select Advanced button, select Network from the
list on the left side of the screen, and then select the LAN tab.

TCP/IP Type: Change this setting to Static.

Media Port: Ensure that this port is set to 9000.

Web Port: Ensure that this is set to 2049.

IP Address: Change this to the IP Address that you wrote down
from the previous section. You will have to enter a zero in front of
any numbers that do not have three digits. Using the example from
previous, this would be 192.168.000.150 after adding the
necessary zeros.

Subnet Mask: This should be set to 255.255.255.000.

Gateway: Change this to the
router’s IP Address (Default Gateway)
that you wrote down from the above section. You will have to enter
zeros in front of any numbers that do not have three digits.

DNS1: This will auto populate.

DNS2: This will auto populate.

UPNP: This should be set to enable if it is not already.
Chapter 18 Remote Access
Write this information on the Information Log at the end of the
manual. Be sure to select Apply and restart the DVR to save all
changes.