GReddy TURBO KITS: Nissan 350Z HR 2007-08 / twin TD06SH-20G - Manual (Page 12)

―１２―
Cau Cau Cau Caution! tion! tion! tion!
• Make sure to check and double check this step. This is the most important step in this install. Make sure to check and double check this step. This is the most important step in this install. Make sure to check and double check this step. This is the most important step in this install. Make sure to check and double check this step. This is the most important step in this install.
• Without proper clearance and thermo wrapping the fuel lines, the fuel line connector can melt Without proper clearance and thermo wrapping the fuel lines, the fuel line connector can melt Without proper clearance and thermo wrapping the fuel lines, the fuel line connector can melt Without proper clearance and thermo wrapping the fuel lines, the fuel line connector can melt
from heat and may catch on fire.
from heat and may catch on fire. from heat and may catch on fire. from heat and may catch on fire.
• Wrap the Starter and the Wrap the Starter and the Wrap the Starter and the Wrap the Starter and the Main Engine harness right Main Engine harness right Main Engine harness right Main Engine harness right
above the transmission bell housing. above the transmission bell housing. above the transmission bell housing. above the transmission bell housing.
Important!
Important! Important! Important!
Make sure that the main engine harness is properly
wrapped and secured away from the manifold and the
wastegate when they are installed.
Caution!
Caution! Caution! Caution!
Without proper clearance and thermo wrapping the
harness, it melt and cause a short in the electrical
system or may catch on fire.
3
33 3- -- -2 2 2 2 Power Steering Line Installation Power Steering Line Installation Power Steering Line Installation Power Steering Line Installation
1. Remove the hose fitting off the power steering pump
and install the provided fitting.
(Parts Used #66)
3 33 3- -- -2 22 2 W W W Water Line Suction Connector ater Line Suction Connector ater Line Suction Connector ater Line Suction Connector Installation Installation Installation Installation
1. Remove the factory water tube and Install the water
line suction connector.
2. Cut the Acryl hose 15Φ to 310mm and Install it
between the Suction connector and the water tube.
Water Line Suction Water Line Suction Water Line Suction Water Line Suction
Connector Connector Connector Connector