GReddy TURBO KITS: Infiniti G35 coupe 2003-04 / twin TD05H-18G - Manual (Page 18)

Brake Check Valve Installation
Install the provided check valve as shown.
(Part Used #39, 46)
Injectors Installation
1. Remove the upper intake manifold collector, fuel rail assembly with injectors and
regulator.
2. Grind the top of the fuel rail as shown to clear the intake manifold.
Make sure not to grind too much. Grind the part on the bracket that is raised down flat.
Clean the rail thoroughly after grinding.
3. Install the 440cc injectors and reinstall the fuel rail using the provided spacer.
(Part Used #65)
4. Cut the factory injector connectors and solder in the provided connector harness.
How to solder
①Strip the end of wires ② Twist the end together
③ Solder the wires ④ Tape up the soldered area
(Make sure to solder
Completely)