GReddy INTERCOOLERS: Nissan GTR 2009- / Type29R User Manual

Page 16

―１５―

３

３－

－

－６

６

６ Air Flow Sensor Extension Harness

Air Flow Sensor Extension Harness

(1) Remove the coupler and the wiring clip of the Air Flow

Sensors.

(2) Cut the Air Flow Sensor Harnesses 2 inches from the

Coupler. The Air Flow Sensor Harnesses will have to

crossed and hardwired via solder. Please use the supplied

wiring Part #14.

(3) The left and right Air Flow Sensor Harnesses will have to

redirected to the opposite sides.

※ Be sure to properly solder the

Be sure to properly solder the

Be sure to properly solder the connections.

connections.

※ Make sure the connections are properly insulated with heat shrink tubing or electrical tape.

Make sure the connections are properly insulated with heat shrink tubing or electrical tape.

(4) We recommend that you secure any loose wires, preferably with zip ties.

３

３－

－

－７

７

７ Engine Start Up

Engine Start Up

(1) Check that all wiring has been completed/ connected, and make sure all tubing and hosing have been

tightened. Once these have been inspected, connect the battery terminals.

※ Make sure the Pedestrian Impact Sensor Harness is attached prior to reinstalling the battery. Otherwise a

Make sure the Pedestrian Impact Sensor Harness is attached prior to reinstalling the battery. Otherwise a

popup hood warning

popup hood warning light will appear on your instrument panel.

light will appear on your instrument panel.

(2) Check the vehicle for any leaks or noises at idle.