beautypg.com

Installatio n, Top hat positioning – GReddy TURBO RELATED: Blow Off Valve Type FV User Manual

Page 4

background image

4-

(1)

Install the blow off valve

to the mounting flange
(sold separately) using the
provided

gasket

and

hardware.

(2)

Connect

the

vacuum

nipple on the top housing
to the intake manifold
pressure source. Use the
three

way

fitting

if

necessary.

(1)

Loosen the M6 lock nut an d screw on top of the Top Hat relieve tension on the
internal springs to make adjustments in Top Hat positioning。

(2)

To rotate the Top Hat, loosen all M4 screws marked A & B one full rotation。

(3)

Remove the screws labeled A to rotate the Top Hat to the Right。

Remove the screws labeled B to rotate the Top Hat to the Left。

※Be sure to only remove screws A or B, removing both may cause the

Top Hat to come off。

(4)

Adjust the hose fitting to the desired location。

※When adjusting to the desired location,
gently rotate the top hat so the internal

diaphragm is not compromised。

(5)

Adjustments can be made up to 90 ° in both
directions。 If more rotation is needed, then the
removal of both screw sets A & B is required。

(6)

Once the desired setting is acquired, replace the M4 screws and tighten

them to the suggested torque specs N・m(kgf・m) 1.2(0.12)

(7)

When Top Hat adjustment is complete, reset the M6 screw and lock nut to the desired setting.

Installatio

n

GASKET

BOLT

FLANGE

Main Body

INTAKE MANIFOLD

PRESSURE

THREE WAY
FITTING

VACUUM HOSE

WASHER

NUT

Top Hat Positioning