GReddy FATT Full Auto Turbo Timer - Manual (Page 21)

Attack Mode
0-200m, 0-400m, 200-400m, 0-100km/h, 0-200km/h, 50-1000km/h Mode
20
This feature allows the user to record 0-200m, 0-400m, 200-400m,
0-100km/h, 0-200km/h, 50-1000km/h times.
Important! - This feature should only be used on a race track where
it is safe. Please never try on the public highways.
*This feature requires the wiring of the vehicle speed sensor signal wire.
*To record 0-200km/h time, the vehicle must be equipped with speed
limiter cut device.
(1) Press P+S+T to go to main Attack Mode. In the attack mode, press
P+S button to go to one of the sub Attack Mode. 0’ 00" will display
indicating that the unit is in stand-by mode.
* When this feature is selected while the vehicle is moving, 0’ 00" will
flash indicating that the unit is not in stand-by mode. Always stop the
vehicle before selecting this feature.
* When the unit is in stand-by mode, press the T button to start the
count down start. This will not work for the 200-400m & 50-100km/h
mode.
* If there are data stored in the Attack Mode memory, --- will flash. To
clear the memory, hold down T button over 5 sec. or change to
different sub mode.
(2) The auto start timing is triggered by the vehicle speed sensor. The
timing will start as soon as the vehicle starts to move.
(3) The recorded time will be displayed until the mode is changed or
cleared.
* To restart the timing in the same mode, or to cancel the timing, hold
down T button over 5 sec. to clear. Then the unit will return to
stand-by mode.