Sper Scientific 850037 Large Display Conductivity Pen - Manual (Page 8)

8
SETUP MODE
The advanced Setup Mode allows you
to customize the pen’s preferences and
defaults:
1. Press SET to turn the pen on.
2. From Measurement Mode, press SET
for more than 2 seconds to enter Setup
Mode and change parameters.
Temperature Units (tUt)
To select the Celsius or Fahrenheit
temperature scale:
1. Press
SET for 2 seconds to enter setup.
2. “t” will appear on the primary display of
the LCD and “P1.0” will appear on the
secondary display.
3. Press SET again for less than one
second to enter the unit setting.
4. Press ▲ or ▼ to select C (Celsius) or
F (Fahrenheit). Press SET for less than
one second to confirm the unit selection.
Press SET for more than 2 seconds to
return to P1.0 without saving.