Sper Scientific 850037 Large Display Conductivity Pen - Manual (Page 27)

27
Temperature Coefficient (tCo)
1. Press ▲ or ▼ to change the
temperature coefficient from 0.0 to 4.0.
2. Press SET for less than one second
to confirm the value or press SET for
more than 2 seconds to return to P1.0
without confirming the temperature
coefficient value.
9
After saving the unit setting, the meter
will automatically enter normalization
temp. adjustment.
P1.3:
In temp. coefficient adjustment
P1.2: Normalization temp.(tnr):
Press " "or " "
o to change the temperature to 20 C
o or 25 C. Press " " momentarily to
confirm the value and meter will enter
next step or press " " more than 2
sec to return to P1.0 without saving.
Temp. Coefficient (tCo)
, press
" " or " " or " " to change the
temperature coefficient from 0.0 to
4.0. Press " " momentarily to
confirm the value or press " " more
than 2 sec to return to P1.0 without
confirming the P1.3 value.
NOTE:
The text P1.1, P1.2, P1.3, P2.1, P3.1
will not display on LCD.
NOTE:
P1.2, 1.3 are invalid in 8371.
P1.1 P1.2 P1.3