Ridetech 11037199 - Manual (Page 3)

3
5. Use a couple clamps to secure the
crossmember between the frame rails.
Slide it forward to the edge of the body
mounts. Drill the holes with a 5/16” bit
and thread the 3/8” x 1” self-tapping bolts
in one at a time.
Do not over tighten the self-tapping
bolts; they can be stripped.
6. The location of the upper Shockwave
mount is determined by measuring
14 ½” from the edge of the bracket to
the large hole in the bottom of the frame.
7. Use a clamp to hold the bracket
against the inside of the frame and drill
the holes with a 5/16” bit. Thread a 3/8”
x 1” self-tapping bolt into the frame after
drilling each hole.
8. Note there is a driver and passenger
side bracket and are stamped
accordingly. When using the correct
bracket the Shockwave will be
perpendicular with the ground.